SMC EliteConnect Wireless Bridge Guide de l'utilisateur télécharger pdf (Page 157)

General Commands

7-9

Example

This example shows how to return to the Exec mode from the Interface

Configuration mode, and then quit the CLI session:

ping

This command sends ICMP echo request packets to another node on the network.

Syntax

ping <host_name | ip_address>

• host_name - Alias of the host.

• ip_address - IP address of the host.

Default Setting

None

Command Mode

Exec

Command Usage

• Use the ping command to see if another site on the network can be

reached.

• The following are some results of the ping command:

- Normal response - The normal response occurs in one to ten seconds,

depending on network traffic.

- Destination does not respond - If the host does not respond, a “timeout”

appears in ten seconds.

- Destination unreachable - The gateway for this destination indicates that

the destination is unreachable.

- Network or host unreachable - The gateway found no corresponding

entry in the route table.

• Press <Esc> to stop pinging.

Example

SMC AP(if-ethernet)#exit

SMC AP#exit

CLI session with the Access Point is now closed

Username:

SMC AP#ping 10.1.0.19

192.168.2.29 is alive

SMC AP#

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 317 318

Pas de commentaire

SMC EliteConnect Wireless Bridge Guide de l'utilisateur Page 157